Appleseed Biodiesel Processors
Appleseed biodiesel processors are the most commonly used processors that have a huge demand in the market even six years down the line. It has a brilliant yet simple design which is its major attractive feature coupled with very common, easy to procure materials. It has been and seems to be the biodiesel kit preferred by thousands of biodiesel brewers.
Benefits of Appleseed Processors
There are certain benefits that the Appleseed biodiesel processor has over others and these are check points that you should look for while buying any biodiesel processor. The tanks of this particular processor are made of quality steel and not plastic or other material that is not a good heat resistor. The processor also has a system which heats the oil internally while it is being converted. Make a mental note, processors that have no internal heating produces low quality biodiesel as the heat speeds up the conversion to produce a good quality biodiesel.
The Appleseed biodiesel processor is also easily expandable, so that if you would like to add on some pre heating tanks or methanol recovery, then you can easily do so. The best plus point of this processor is that it uses parts that are very easily available at hand and so is something is damaged or you need to replace any part you can find it like that rather than searching for it in the entire country. The feel good part however is that there is a huge community out there in the internet using this processor and is eager to help you should you face any problem.
Even the price of the processor is awesome. With all the parts that you have to put together and all the material that you need to buy, your Appleseed biodiesel processor will take you less than even one thousand dollars to set it all up. Compared to the other biodiesel processors that is really very cheap. Usually the other processors have a total cost count of almost four thousand dollars and so you do understand when I say that the Appleseed biodiesel processor is very cheap.
Many have said that the processor could be made much better by using a cone shaped tank rather than a flat bottomed tank. This is so because people say that the cone bottom would facilitate easy removal of glycerine from the bottom of the tank, leaving behind the pure biodiesel. But the truth is not that. When the two layers are formed there is a grey area in between which contains glycerine, some water maybe and biodiesel and you will have to let go of this if you want pure biodiesel.
True that the cone bottomed tanks helps do it slightly better but that is no reason why you should spend a huge $3000 or even more to get a cone bottomed tank! The idea is preposterous. So whatever anyone else says donot listen to that, use your own brains and get the Appleseed biodiesel processor today.